how to finish a wood kitchen table top
Tabletop finishing: seal end grain. the end grain of wood soaks up finishes and often turns much darker than the face grain. check for this on your test block. if you get an ugly result, pretreat the end grain with a dose of finish that will limit absorption (wood conditioner, sanding sealer, shellac or polyurethane thinned 50 percent).. Wood-finishing expert bruce johnson shares his secrets for applying a professional-quality stain and varnish finish. (see below for a shopping list, tools, and steps.) subscribe to this old house. 1. sand the entire table to remove all stain from edges and legs. if using an orbital or belt sander, be careful not to gouge the surface. do most of the initial sanding and varnish removal with the 100-grit sandpaper, then step up to 150-grit and do a final pass with 220-grit to smooth out the grain for the new finish..
how to finish a wood kitchen table top
When finishing a kitchen table, you want it to be beautiful but you also need it to be tough. if you exclude professional finishes such as catalyzed lacquer or urethane, polyurethane is probably the toughest finish you can find. water-based polyurethane finishes have low vocs and dry within an hour or two, but they can look plasticky if applied too thick or in haste.. 3. brush a coat of wood conditioner onto the wood, which will allow the stain to soak in evenly without blotching. 4. after applying the conditioner, wait at least 15 minutes, but no more than 2 hours, before staining. 5. liberally apply wood stain to the surface using a paintbrush or clean cotton cloth. 6..
No comments:
Post a Comment